Tong Family

DRAM Settings for DFI NF4 (all) VX, TCCD/TCC5, BH-5, 3200 Gold & General BIOS Info – Forums on the BleedinEdge. Wow what a great site I just found that talks about really making OCZ fly. Nice to have a memory vendor who knows their audience.

Some quick things I learned:

* All OCZ memory seem to work better with the -2 variants. They recommend the 5120-2, 704-2BT, 704-2BTA. Put the memory into the yellow slots. As always depending on board revisions, some do better with the -3 (all official BIOS are -3 based). Others work better with orange slots. The true power nerd has to try two sets of BIOS and two sets of memory cards.
* The Tref in the Dram settings seem to need the most tweaking, they reocmmend 3120 or 4708 for TCCD/TCC5 memory which would include the OCZ PC3200 Platinum Rev 2, PC3700 Platinum , PC4200 Platinum and PC4800 Platinum). You need to have this when overclocking above 250MHz FSB
* Tref of 0648 works bets for VX or 3200/3500 Gold/GX memory
* The true nerd should try 0648, 0780, 1168, 0016, 0032, and 2336 and this might work better.
* Don’t use this board with a 20 pin PSU
* If you don’t boot, this happens with OCZ VX quite a bit. Make sure you only use the Orange slots for the official or -3 BIOS.
* To test memory, boot one stick in slot 2 (the farthest orange slot from the CPU). If one boots, but the other doesn’t you have a bad memory stick.

This site also has specific and very detailed notes on settings for memory. For instance for a late model San Diego or Venice, Winchester, Hammer or Newcastle with OCZ VX, 3200 Gold or 3500 Gold GX (that is CH-5 memory, here are the setting needed. Here are the settings for the Genie BIOS:

200
enable
2.0
02
06
02
07
16 or 14
03 or 02
03
02 or 01
03 or 02
0648, 2560 or 3120 (0648 has worked on many systems)
auto
enabled
auto
0
level 8
level 2
auto
DRAM Respnse Time: fast or normal (as needed if your BIOS has this feature.)
auto
256
disable
16
07
disable

In Genie Bios

200 and higher (start at 230mhz or so and work up)
auto
16 16
7 (for testing, then adjust for max overclock)
100
disable
1.500v
1.300v [/b](This is about 1.57v, if you need more do not go past 1.45v here, use more the 123% below, there is a reason ) [b]
above VID * 123%
1.30v
1.70v
3.3v-3.4v (up to 3.5v for Gold and Gold GX)

Also there is this strange thing called Drive strength and here are the settings for TCCD/TCC5 try 3, 5 or 7. I f you have the OCZ VX or the new BH Gold then try 8 or 6